Bus four-input and four-output module
A bus module that provides four wired inputs with adjustable EOL resistor values, four galvanically separated signal PG outputs and an auxiliary power supply, protected with an electronic fuse.
Besides the EOL resistor type, the values of resistors can also be set for the inputs. The outputs are designed as galvanically separated ones (two have a common C terminal in each case). The module occupies four positions in the control panel and it is equipped with a front and rear tamper sensor.
It is mainly suitable for the refurbishment of wired alarms, where old detectors are kept. They are also very frequently used to control multiple appliances through the PG outputs. The auxiliary power supply makes it possible to supply current to boost relays connected to the signal output.
Specifications
- Compatible with: F-Link 1.4.0 or higher
- Power: via the control panel bus: 2 V (9…15 V)
- Backup mode consumption: 25 mA + consumption of connected devices
- Current consumption (maximum) for cable selection: 25 mA + consumption of connected devices
- Maximum current from an output +U (electronic fuse): 200 mA
- Maximum current / voltage switched by each output: 500 mA / 38 V
- Max. measured resistance at an input: 20 kOhm
- Max. length of supply lines of the inputs: 100m
- Dimensions: 77 x 40 x 31 mm
- Classification: security level 2, ACE type B in accordance with: EN 50131-1, EN 50131-3
- Environment: II. indoor, general in accordance with EN 50131-1
- Operating temperature range: -10 °C to +40 °C
- It also meets the requirements of: EN 50130-4, EN 55022
A bus module that provides four wired inputs with adjustable EOL resistor values, four galvanically separated signal PG outputs and an auxiliary power supply, protected with an electronic fuse.
Besides the EOL resistor type, the values of resistors can also be set for the inputs. The outputs are designed as galvanically separated ones (two have a common C terminal in each case). The module occupies four positions in the control panel and it is equipped with a front and rear tamper sensor.
It is mainly suitable for the refurbishment of wired alarms, where old detectors are kept. They are also very frequently used to control multiple appliances through the PG outputs. The auxiliary power supply makes it possible to supply current to boost relays connected to the signal output.
Specifications
- Compatible with: F-Link 1.4.0 or higher
- Power: via the control panel bus: 2 V (9…15 V)
- Backup mode consumption: 25 mA + consumption of connected devices
- Current consumption (maximum) for cable selection: 25 mA + consumption of connected devices
- Maximum current from an output +U (electronic fuse): 200 mA
- Maximum current / voltage switched by each output: 500 mA / 38 V
- Max. measured resistance at an input: 20 kOhm
- Max. length of supply lines of the inputs: 100m
- Dimensions: 77 x 40 x 31 mm
- Classification: security level 2, ACE type B in accordance with: EN 50131-1, EN 50131-3
- Environment: II. indoor, general in accordance with EN 50131-1
- Operating temperature range: -10 °C to +40 °C
- It also meets the requirements of: EN 50130-4, EN 55022
